Advantages of using the ANSI/ASHRAE tracer gas test method vs. the ANSI/AIHA. Z face velocity test method for the. expressed in feet per minute (fpm) or meter per second (m/s) (ANSI/ASHRAE necessarily involving the use of a bench or a table (ANSI/ASHRAE , ). SEFA (Scientific Equipment Furniture. Association), formerly SAMA (Scientific. Apparatus Manufacturer Association). (recommended practices). ▫ ASHRAE .
|Published (Last):||28 December 2009|
|PDF File Size:||9.47 Mb|
|ePub File Size:||14.26 Mb|
|Price:||Free* [*Free Regsitration Required]|
Vol 6 No 1 Evaluation of laoratory hoods in Tehran Water and Waste water Co. Chemical Health and Safety.
Interpretations For Standard 110-1995
Tracer performance testing of installed fume hoods: The environmentally hostile characteristics of SF6 as well as its cost are the major concerns. Taylor, Scott and Tufts Climate Initiative. A new method for quantitative, in-use testing of laboratory fume hoods.
American National Standard for Laboratory Ventilation. Skip to main content Skip to main navigation menu Skip to site footer. SF 6 is extremely hostile to environment and expensive.
Exploring the use of less environmentally damaging gases for use in tracer gas testing. Lawrence Berkeley National Laboratory. Laboratory awhrae hood performance. Dale T, Maupins K. Laboratory hood, Tracer gas, Ethylene, SF6. Taylor S, Initiative TC. Design, Construction, Maintenance, Health and Safety. The performance of a laboratory hood was evaluated using ASHRAE standard method at three different ventilation capacity as well as three different volumetric flow rates of injected SF 6 while a mannequin was located at the front of hood.
UC Lab Safety Workgroup. Alternative gases to meet.
Ashrae Std Testing Laboratory Fume Hoods
Method of testng performance of laboratory fume ashrad. Significance of face velocity fluctuation in relation to laboratory fume hood performance. Application of non-dispersive infrared NDIR spectroscopy to the measurement of atmospheric trace gases.
In this test, sulfur hexafluoride SF6 is applied as a tracer gas to quantitatively evaluate the performance of laboratory hoods.
Face velocity was measured times using a thermal anemometer TA-2 ashare. Meanwhile, the exposure of a mannequin stationed at the ashrea of hood was measured. A considerable amount of sulfur hexafluoride is applied to evaluate the performance of each laboratory hood according to ASHRAE— method. Am Ind Hyg Assoc ;59 2: The concentration of tracer gases was measured using direct reading instruments.
Ind health ;48 1: Choosing less environmentally damaging gases for fume hood tracer gas testing.
Linear regression of the results was used to consider the substitution of ethylene with SF6. The occupational exposure of the proposed hood operator to SF6 and ethylene were 4. Islamic Azad university; The average and standard deviation of face velocity at hood inlet were 0.
The application of ASHRAE hood performance test with smaller volume of tracer sulfur hexafluoride gas is not recommended. Hitchings DT, Maupins K. Shahid Beheshti University of Medical Science; Ann OccupHyg ; 51 2: Massachusetts Institute of Technology.
Laboratory fume hood performance.
Air flow was visualized through injecting low and high volume of smokes at 18 tests. Tracer gas evaluations of push-pull ventilation system performance. Evaluation of laoratory hoods in Tehran Water and Waste water Co. Industrial Ventilation a manual of practice for designe 27th ed. Appl Occup Environ Hyg ; 15 2: Chemical Fume Hood Guide: